Good point! Any recommendations for a reliable BCG?
I always go with Toolcraft for BCGs. They have a solid reputation and work great with 6.5 Creedmoor setups.
8 Likes
That’s a solid choice. What about upper and lower receivers? Should I stick with matched sets or mix brands?
6 Likes
Matched sets are usually the way to go for fitment and stability, but many users have success with different brands too!
I’m all for mixing brands sometimes. Just make sure they are within mil-spec—gives some flexibility without sacrificing too much quality.
Why go for mixed? Just stick with a single brand to avoid compatibility issues! Trust me, I learned the hard way.
7 Likes
That’s valid. Any brands you’d recommend then for a complete AR-10 setup?
2 Likes
I really like Palmetto State Armory for budget-friendly builds. They have a variety of parts and accessories that perform well.
PSA is a great choice for budget, but if looking for premium, I’d lean towards JP Enterprises. Just be prepared to spend a bit more.
I’m excited to dive into 6.5 Creedmoor reloading! I’ve been using Hodgdon H1000 for my loads, and I’ve had great success. What powders have others had luck with?
4 Likes
I’ve found Varget to be really consistent for my AR-10. It burns cleanly and works well with heavier bullets. Anyone else using Varget?
I also enjoy using Varget, but I’ve had good results with IMR 4064 as well. The key is finding the right match for your specific rifle setup!
Just a thought—what bullet weights have you been using? I’ve mostly stuck with 140gr for accuracy at distance. Anyone experimenting with lighter bullets?
I’ve played around with 123gr and found them to be surprisingly effective! It really depends on what you’re chasing with your load development.
Agreed! While 140gr are great, I think lighter weights can shine in windier conditions. I say, why not mix and match weights for different scenarios?
5 Likes
That’s a smart approach! Versatility is crucial. What about case prep? Any strategies to enhance performance?
For case prep, uniforming the primer pockets has been a game-changer for me. Increased consistency in ignition means better groups down range!
Don’t forget about annealing! It can help with neck tension and consistency, especially with multiple firings. Just make sure you don’t go too hot!
So true, too hot can ruin cases quickly! By the way, how often are you guys adjusting your loads? Is it a constant experiment or do you stick to a favorite?
I tend to stick to one load for a while, but I’ll change things up for testing new powders or bullets. It keeps the joy in reloading alive!